D’oh! A Deer!

Posted 2012.10.21 12.51 in Uncategorized by Stephanie

Filed under Things You Don’t Expect To Encounter While Walking Downtown.

Halfway around the block from my house, in a little parkette, was this doe munching quietly on some leaves.¬†She didn’t seem to mind the handful of us who stopped to watch and snap some pictures.

Remarkable.

Mark III Rev D – It’s Alive!

Posted 2012.10.21 10.40 in Computers/Internet/Technology by Stephanie

The ISEB-6 Mark III revision D is alive! I put the finishing touches on the soldering this morning. All that’s left now is finalizing the software. And making the actual leather bracer. And mounting the electronics. And building a slick enclosure. And…

Ok there’s a lot more to go yet. But still – look!

Isn’t it kewl?

The only real bother I ran into was the display’s only got 3 bolts instead of 4. It’s still sturdy, the data connections are all soldered solid. The problem was when I routed all the traces, I forgot to leave room on both sides of the board for the hardware. So the top-left corner under the screen has two SMD resistors that would short against the nut, and the bottom of the board has two traces that would be cut if I counter-sunk the hole to accomodate the flat-head bolt. Bummer.

Apart from the problem with that one bolt, everything else went together fairly smoothly. Mostly.

The image below shows it almost ready for the screen – the BMP085 is in place for sensing temperature and air pressure; the ADXL345 is in place for measuring accelleration. I’ve also added a white LED to serve as a flashlight, and with some creative snipping and soldering, I fit the Lillypad Vibration motor in underneath the screen too!

When the whole thing’s done and finished, I’ll be posting everything (code, board layout, BOM, assembly) so anyone can make their own ISEB-6.

Also noteworthy: there are still two available analog inputs (A0 and A1) and three available digital IO ports – B2, C2, and C3. Expansion possibilities!

I positioned C3 near the ICSP port so one could add a SPI peripheral by using C3 as a slave select (the display is already using the default SS pin). C2 is on the sub-board with the buttons, to allow expansion there. The other three available I/O pins, along with the I2C bus and power are available at the top edge of the board for easy expansion.