You are currently browsing the interface tag archives.

Pointless Dingoo Mods

Posted 2010.04.22 9.44 in Computers/Internet/Technology by Stephanie

Last night I was a bit bored so I sat down and did some pointless hardware mods to my Dingoo.

First, I added a power LED. When the backlight is off, or if you boot it with the B button to go into flashing mode, it’s hard to know if the Dingoo is on or off. And in any event, I’m a sucker for LEDs. “Real electronics should glow in the dark.”

The easy part was attaching the LED, I used a surface mount blue LED that draws 10mA at 3.6v and stuck it near the start button, then wired it between Vcc and ground. I found a point on the rear of the board where the power is switched so I just ran a bit of 28 gauge wire around from the back to the front. The hard part was getting a hole in the black layer of the front case, without also going through the clear part of the front case. I used a cheap soldering iron to melt some of the plastic then some small precision chisels to cut out the plastic and get the hole to be just about right. Actually it was about 80% luck, I’m usually not this good at modifying the plastic parts.

Read more »